Appendix G-2
1998-2006 Edition
3 PIECE MITERED GLASS KIT
INSTALLATION (Continued)
Step 4: Locate the side Gloss Retainer Mounting Holes, These holes should already be drilled and topped
on both sides of the door.
Step 5: Loosely attach one Gloss Retainer Bracket to each side of the cost iron door using one #8 x 1/2” self
topping Phillips screw.
Step 6; Check the joint between the center gloss and the side glass pieces, Center the center piece then
gently push the side glass pieces towards the center pieces until they butt together, lighten the glass retainer
bracket mounting screws carefully.
NOTE: FOR PELLET STOVE APPLICATIONS, IT IS NOT NECESSARY FOR THE JOINT BETWEEN THE
SIDE AND CENTER GLASS TO BE A PERFECT SEAL. GAPS AS LARGE AS 1/32” (0.8mm) ARE
ACCEPTABLE AND WILL NOT AFFECT THE PELLET STOVE FUNCTION.
Step 7: Locate the Glass Retainer Mounting Holes located along the top edge of the center gloss, If there
are two screw holes, attach one glass retainer bracket to these holes by following Steps #5 & #6, If only one
hole exists of the center (along the top edge of the center glass), you will need to use a glass retainer
bracket as a template and mark the center of the two mounting holes, Use a #29 drill bit to drill holes 1/2”
(13mm) deep and tap them using a #8-32nc Tap.
Summary of Contents for J1000B
