Jamesway Incubator Company
Part Name / Description:
Platinum 2.0 Center ECU Support
Instruction #:
JIC-INSTP2-00004
Page
7
of
17
Operation Instruction Title:
Platinum Centre ECU Support
Revision Date: 04/03/2018
Revised By: V. Frail
Revision No. A
Approved By: S. Ditner
Page
7
of
17
JIC-INSTP2-00004 Step 17
Solder the solenoid valve assemblies to
the outside pipe assemblies and the check
valves to the inside pipe assemblies.
Ensure that the valves sit 90° to the center
support and are inline down the cabinet.
JIC-INSTP2-00004 Step 18
Silicone around the pipe/roof joints both
inside and outside the cabinet.
Leave the support 2x4s in place for at least
24 hours while the silicone dries.
JIC-INSTP2-00004 Step 19
Support the plumbing using the pipe
clamps
–
four at the center support shelf,
and four on the roof of the cabinet.
Electrical Conduit Assembly
JIC-INSTP2-00004 Step 20
The wiring for the solenoids runs from the
console, through the low voltage duct of
the centre roof extrusion and down
through PVC conduit to a connection box.
Ensure the pre-drilled hole in the centre
roof extrusion is fitted with a snap
bushing.
