4
4
When installing the KP4.6 in a J box all knock outs must be re-
moved to provide ventilation.
Do not install the KP4.6 in a double gang box that also has elec-
trical installation in it. If installed next to electrical installation
either a barrier-box or two single gang boxes must be used.
Do not install the KP4.6 where it can be exposed to direct sun
light or strong fluorescent tubes as both can interfere with IR
remote controls.
Do not install the KP4.6 close to a plasma TV as they can also
interfere with IR remote controls. A distance of 15 feet is safe
with most plasma TV’s.
Do not install the KP4.6 close to dimmer switches as they gener-
ate noise.
Do not install the KP4.6 in areas with high humidity or outdoors.
Do not install the KP4.6 within line of sight to another KP4.6.
This could make it difficult to control each zone separately with
a remote control.
Do not install the KP4.6 within line of sight to the source equip-
ment. This could interfere with the operation of the source
equipment if receiving IR commands directly and through the
KP4.6.
The KP4.6 operates on 24V DC supplied through the CAT5e
cable and can therefore often be installed in locations only per-
mitted for Extra Low Voltage (ELV) equipment. If in doubt, check
the wiring regulation for your application in your area.
Important
