Getting Started
HT1
User Manual
Janam Technologies LLC Version 1, September 2020
Getting Started 2—3
Once all four retaining sliders are in the open
position, use a plastic opening tool, a
fingernail, or a small coin to carefully pry
open and then remove the battery
compartment cover. If you use a coin or
metallic tool such as a flat blade screwdriver,
make sure not to scratch the housing or
damage the compartment seal.
Make sure the battery locking slider is in the
open position (indicated by an open padlock
icon). Insert the battery, with the Janam logo
and battery information facing you, into the
compartment. Once it is firmly seated, glide
the battery lock slider into the locked posi-
tion.
Before putting the battery compartment
cover back in place, check for the presence
and condition of the white seal along the in-
side perimeter of the cover. If the blue seal
is damaged or missing, replace it. Do not op-
erate the HT1 with a missing or damaged
battery compartment seal, as this could
allow liquids to enter and damage the device.
To put the cover back on, insert its upper
part first. Then, starting with the upper part,
gently close the cover until all of the cover clips have snapped into place. Slide all four cover locks
into their locked position.
Charging the HT1 battery
To charge the battery using the
DC Power Adapter Kit
:
1. Slide the appropriate US/UK/EUR adapter plug onto the AC/DC power adapter housing.
2. Insert the USB Type-C cable into the USB Type-C port at the bottom of the HT1.
3. Plug in the AC/DC power supply. The HT1 LED indicator will light blue while charging
and will change to green when fully charged.
Use only easily accessible wall sockets that are
easily reached with the length of the supplied power cable.
