XG100CE User Manual
2-5
Janam Technologies LLC
To charge the battery using the USB Syncing/Charging Cable or Serial Syncing/Charging Cable:
1. Connect the power supply to the USB or serial syncing/charging cable.
2. Connect snap-on end of USB or serial synching/charging cable to syncing/charging connector at the
bottom of device, making sure the JANAM logo on the connector faces up.
3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that
are easily reached with the length of supplied power cable.
To charge the battery using the Single-Slot or Four-Slot Cradle:
1. Connect the power supply to the cradle.
2. Connect the line cord to the power supply.
3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that
are easily reached with the length of supplied power cable.
4. Place the device in cradle. The LED will illuminate to confirm connection (orange indicates charging, green
indicates fully charged and red indicates fault).
5. The battery is fully charged in approximately 5 hours.
6. For
Single-Slot cradle only: Charge a spare battery by placing the battery in the spare battery well with
connectors lined up. An LED will illuminate to confirm connection.
Charging a Spare Battery in Single-Slot Cradle Spare Battery Well or Four-Slot
Battery Charger
1.
Insert and slide the battery into the charging slot as shown.
2.
Press down and forward with index finger to fully seat the battery.
3. The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
4. The battery is fully charged in approximately 5 hours.
Turn the XG100CE on
After batteries have been charged for required length of time, press the red power
button located on the keypad to the right of the up/down/left/right arrow keys.
The first time the device is turned on, calibrate the screen using the stylus. To
calibrate, simply follow the on-screen instructions and remember to save your
settings.
Note:
If your XG100CE came pre-loaded with a custom software application, a welcome
utility may not appear. If this happens, follow the on-screen instructions.
