XM2-RFID
User Manual
2-2
Janam Technologies LLC
Attaching the Handstrap
To attach the handstrap:
1.
Separate the velcro of the handstrap.
2.
Feed the loose end of the extended handstrap through the handstrap clip.
3.
Wrap the handstrap around the clip and fasten together to close the strap.
Installing the MicroSD Card and Battery
To install the MicroSD Card:
1.
Remove battery if necessary.
2.
Insert MicroSD card into the card slot.
3.
Make sure the card connector (golden contacts) is facing the top of the device.
To install the battery:
1. If battery cover is installed on the device, slide the battery latch to the left.
2. The battery cover will lift up slightly. Grasp the battery cover and remove it.
3. Insert the battery, left side (with golden contacts) first, into the battery compartment.
4. Press the battery down until the battery fully rests on the bottom of battery compartment.
5. Put the battery cover back, tab first, and press down until the latch secures the battery
cover.
To remove the battery:
1.
Slide the battery latch to the left.
2.
The battery cover will lift up slightly; grasp the battery cover and remove it.
3.
Remove the battery, right side first, from the battery compartment.
