XM60 User Manual
2-2
Janam Technologies LLC
Install the battery
IMPORTANT Battery Warning!
CAUTION: Use only Janam-approved batteries.
There is the risk of explosion if battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions.
1.
To access the battery compartment, turn the locking-screw counterclockwise to open the latch
and remove battery cover.
2.
Position the battery lift strap against the back of battery well, ensuring tab extension is on left side.
3.
Place a Janam Lithium-ion rechargeable battery in and snap into place.
4.
Replace the battery cover by positioning the top prongs first and sliding into place. Tighten locking-
screw by turning clockwise.
To charge the battery:
Important Note: The main battery charges the backup battery in the XM60. Once the main battery is
fully charged, do not remove it from the unit for 24 hours. If the battery is removed during this period,
the device cannot maintain any user data.
To charge the battery using the USB syncing/charging cable or serial charging cable:
1. Connect
the
power supply to the USB syncing/charging cable or serial/syncing charging cable.
2. Connect
snap-on end of USB syncing/charging cable or serial/syncing charging cable to bottom of
XM60, making sure the word TOP on the connector faces front.
3. Insert
country-specific AC plug, and plug in the power supply.
4. The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
5. The battery is fully charged in approximately two hours.
To charge the battery using the single-slot or four-slot cradle:
1. Connect the power supply to the cradle.
2. Connect the line cord to the appropriate power supply.
3. Plug in the power supply.
4. Insert the XM60 into the cradle. Important: Proper insertion is required to ensure connection. Be
sure to insert the device as follows:
•
Place the XM60 in cradle well (seating the device without trying to join connectors).
•
Tilt-rotate the XM60 forward (bringing the top end of the unit forward) as you apply downward
pressure to fully insert in cradle well, joining connectors.
5. The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
6. The battery is fully charged in approximately two hours.
Remove the battery from spare battery charging well
Do not force-pull the battery from charging well. Follow these instructions to remove the battery:
1.
While gently holding down with thumb, slip index finger down against the battery so that you feel the
edge where the battery meets the cradle.
2.
Press down and forward with index finger to lift battery edge.
Turn on the XM60
The first time the device is turned on, calibrate the screen using the stylus.
The stylus is located on the back of the device. To calibrate, simply follow the
on-screen instructions and remember to save your settings.
Note: If your XM60 came pre-loaded with a custom software application, a
welcome utility may not appear. If this happens, follow the on-screen
instructions.
