XP20 User Manual
2-3
Janam Technologies LLC
Attach the hand strap
1.
Push the thin, looped portion of the strap through the left- or right-side of hand strap connector on the
back on the handheld (see item 8 in hardware overview).
2.
Thread the Velcro part of the strap through the loop at the bottom of the terminal and pull tight.
Install the battery
1.
To access the battery compartment, turn the locking-screw counterclockwise to open the latch and
remove battery cover.
2.
Position the battery lift strap against the back of battery well, ensuring tab extension is on left side.
3.
Place the Janam Lithium-ion rechargeable battery in and snap into place.
4.
Replace the battery cover by positioning the top prongs first and sliding into place. Tighten locking-
screw by turning clockwise.
To charge the battery:
Important Note:
The main battery charges the backup battery in the XP20. Once the main battery is
fully charged, do not remove it from the unit for 24 hours. If removed during this period, the device
cannot maintain any user data if the battery is removed.
To charge the battery using the USB syncing/charging cable or serial charging cable:
1.
Connect the power supply to the USB syncing/charging cable or serial/syncing charging cable.
2.
Connect snap-on end of USB syncing/charging cable or serial/syncing charging cable to bottom of
XP20 making sure the word TOP on the connector faces front.
3.
Insert country-specific AC plug and plug in the power supply.
To charge the battery using the single-slot or four-slot cradle:
1.
Connect the power supply to the cradle.
2.
Connect the line cord to the appropriate power supply.
3.
Plug in the power supply.
4.
Insert the XP20 into the cradle.
Important
: Proper insertion is required to ensure connection. Be
sure to insert the device as follows:
•
Place the XP20 in cradle well (seating the device without trying to join connectors).
•
Tilt-rotate the XP20 forward (bringing the top end of the unit forward) as you apply downward
pressure to fully insert in cradle well, joining connectors.
5.
The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
6.
The battery is fully charged in approximately two hours.
Remove the battery from spare battery charging well
Do not force-pull the battery from charging well. Follow these instructions to remove the battery:
1.
Position hand with index finger at position A and thumb at position B (reverse for left-hand).
2.
While gently holding down with thumb, slip index finger down against the battery so that you feel the
edge where the battery meets the cradle.
3.
Press down and forward with index finger to lift battery edge.
Turn on the XP20
The first time the device is turned on, a Welcome Wtility appears. To set up the device, follow the on-screen
instructions, which include locating and using the stylus, screen calibration and date/time settings. To access
the welcome utility at a later time, go to the
main or applications menu (home)
and select the
welcome
icon
.
Note:
If your XP20 came pre-loaded with a custom software application, the Welcome wtility may not
appear. If this happens, follow the on-screen instructions.
