Regulatory and Maintenance
XT1
User Manual
Janam Technologies LLC
Version 1, March 2015
12
―
3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions. The user may find the following booklet helpful: “Something about
Interference.” This is available at FCC local regional offices. Our company is not responsible for any
radio or television interference caused by unauthorized modifications of this equipment or the
substitution or attachment of connective cables and equipment other than those specified by our
company. The correction is the responsibility of the user. Use only shielded data cables with this
system.
This device and its antenna must not be co-located or operating in conjunction with any
other antenna or transmitter. To maintain compliance with the FCC RF exposure guidelines
for body-worn operation, do not use accessories that contain metallic components other
than specified by the manufacturer.