j&a EMPRESS GT, User Manual

Up to3 ft +/- 45 sec. with 3/4” outlet

3/4” Discharge Pipe Outlet

Drain outlet MUST be 3/4”
pipe for efficient drainage

3/4” x 3/4” Brass
swing check valve Required

Note:

Operation Instruction

Warning ! DO NOT RUN DRY

1. 

Turn to open drain plug. 3 to 5 second for air to release from the pipe

2. 

Press On/Off switch to activate timer. 

3. 

At any time, water drain completely from the basin. Press 

On/Off switch to stop built in two minute timer.

1.  Make a hole ( size 1-3/8”) for the On/Off switch as shown (see fig 1)
        pre-drilled 
2.  Placed a 1/8” clear hose into the rear of the switch and on/off switch 
        into the hole.
3.  The discharge pump kit is made to fit onto the pedicure unit. (see fig 2)
4.  Connect E-Z connector onto the drain elbow.
5.  Plug discharge pump outlet into the two minute timer outlet
6.  Plug two minute timer into the wall outlet.
7.  It is very important that tip of the clear tub remain above the water
        level

** Please cut to fit Flex hose to size**

Installation Instruction

Power Plug
to wall outlet

FULL TIME

PA

R

T

 T

IM

E

PA
R

T

 T

IM
E

2 Min.Timer
  (D.pump)

L

ig

h

t 

T

ra

n

sf

o

rm

e

r

Pipeless Motor
Power Plug

1/8” clear Tube
from On/Off Switch
for Part time control box

3/8” Clear Tube from on/off for D/P pump
insert into 2 Min. Timer.
Make sure to push in tightly.

Electrical Control Box

(SMALL Rubber Coupling)

Elbow 

  (LARGE Rubber Coupling)

LARGE Rubber Coupling

3/4” PVC Pipe

               Pump

3/4” Elbow

Rubber Gasket

3/4 PVC Pipe

3/4” PVC Pipe

TEE 3/4 X 3/4 X  ½” 

Poly Insert 90 Elb ½”

Clear Tubing 3/4 OD ½”ID 

Air Check Valve

Empress GT: Discharge Pump (Optional)

Model: TS-B40-3A
Rating: 120VAC. 60Hz. 0.8A. 75W
Flow Rating: 6 Gal. Per Min.
Max. Lift: 3 FT.