12
Caution
To reduce the potential risk of fire, electrical shock, or injury to persons:
1)
All electrical wiring (both installation & repair) must be done by a licensed electrician and in
accordance with local and state ordinances.
2)
No modifications, additions or deletions should be made to the pump, without factory
approval.
3)
Before stating motor, fill up the tub with water to level recommended by whirlpool
manufacturer. Never run pump dry!
4)
Do not relocate pump without prior approval from factory.
Warning
To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
To reduce the risk of electric shock, replace damage cord immediately. And do not use extension
cord to connect unit to electric supply; provide a properly located outlet.
TROUBLESHOOTING GUIDE
SYMTOMS
PROBABLE CAUSES
RECOMMENDED ACTION
Pump will not turn on No power to motor
Check switch, fuse or breaker, also
connection from motor to switch
Pump runs slow
Pump not wired same as
voltage supplied
Check pump to connect voltage
