4b
Please read over all instructions carefully before you
begin. If you have any questions please call your local
dealer, or contact J&D Manufacturing at 1-800-998-2398.
This is the preferred method of installation. If the wall you are using is
exceptionally thick, or if you wish to have the shutter mounted to the
outside of your building, the ALTERNATE INSTALLATION may be used.
Construct a structurally sound rough opening for your fan.
1
INSTALLATION
Insert exhaust fan shutter into finished opening making sure that shutter
can move freely. Exhaust fan must be mounted with the motor inside of
structure, protected from the weather, and with capacitor on top as shown.
2
Capacitor
Width
Height
Fan Size
10”
12”
16”
20”
24”
30”
___________________
___________________
___________________
___________________
___________________
___________________
Height
10½”
12½”
16½”
20½”
24½”
30½”
Width
10½”
12½”
16½”
20½”
24½”
30½”
Inside of structure
Outside
Direction
of airflow
Direction
of airflow
Using appropriate hardware (not provided) for your structure and the
weight of your exhaust fan, secure the fan to your structure using the (4)
pre-drilled holes on the flange.
3
• Install manual disconnect switch inside building adjacent to
fan per national, regional,and local electrical codes.
• Route wire to motor with drip loop and secure. Drip loop will
drain accumulated moisture away from the motor.
• Configure internal wires to match supply voltage and wire
according to motor nameplate. Test to verify correct rotation.
• Only permit power to unit when shutter and guard is fully
installed to prevent injury.
Separate variable speed control is required to adjust fan speed.
Contact your dealer for more information.
MAINTENANCE INSTRUCTIONS
• Disconnect power before cleaning or maintaining your fan in order
to prevent serious injury or death.
• Service and repair of fan should only be completed by a qualified
technician.
• For maximum efficiency and fan life, keep the following free from
dirt and dust:
-
blades
-
housing
-
shutters
-
motor
-
guard
• The totally enclosed air over motor has sealed ball bearings and
does not require additional lubrication.
STANDARD INSTALLATION
ALL ELECTRICAL WORK SHOULD BE
COMPLETED BY QUALIFIED PERSONNEL
AND MEET NATIONAL, REGIONAL
AND LOCAL CODES.
4a
• Plug cord into 115 AC grounded outlet that meets national,
regional and local codes.
• Route electrical cord from motor to outlet with drip loop.
Drip loop will drain accumulated moisture away from the
motor and outlet.
• Only permit power to unit when shutter and guard is fully
installed to prevent injury.
Separate variable speed control is required to adjust fan speed.
Contact your dealer for more information.
POWERING UNIT
The ES Shutter fan is available with or without a pre-wired cord. If the
model you purchased includes an attached cord, proceed to step 4a for
instructions on powering your fan. If you purchased a model without a
cord, proceed to step 4b for wiring instructions.
IS209-11I
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 2 of 3
