• Assemble
(2) SS
Eyebolts
and (2) SS
Serrated Flange Nuts
#10-24
from
Bag 9 (Misc. Hardware)
— With the flange facing up thread (1)
Serrated Flange Nut
onto
each
Eyebolt
as far as it will go.
• Insert each eyebolt nut assembly up through the hole drilled in
Step 3
and secure with a
SS
Serrated Flange Nut
#10-24 from
Bag 9 (Misc.
Hardware)
, flange facing down.
• Using 3/8” wrench tighten each eyebolt assemblies
NOTES:
- Turn the eyebolts so the opening of the loops are facing each other.
-
Where the eyebolts are installed is now considered the TOP of
the fan
.
4
Housing Side Panel Assembly:
• Starting on a corner and with the front and back venturi section channels
inserted into the grooves of the housing side panel.
• Slide the housing side panel across the top until it hits the center seam of
the assembled venturi sections.
• Lift up on the center of the housing side panel and continue to slide
housing side panel until it is centered.
• Repeat until all four sides have housing side panels installed
5
IS295-20H
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 4/12
Location of eyebolts=
Top of Fan
