Installing Housing Corner Caps:
• Place a
housing corner cap
onto the housing between (2)
housing side
panels
assembled in the previous step.
• Using the included
#3 Phillips Bit from Bag 1 (Tools)
and (6) #14-
10 x 2”
Screws from Bag 2 (Part 3)
, screw the corner to the panels.
NOTE:
- The screws should draw the
housing side panel
up tight to the
housing corner cap
, but the
housing side panel
may need to be
pushed/pulled as it is being screwed together.
• Repeat until all four
housing corner caps
have been installed
6
Motor Installation:
NOTE:
2 person lift is recommended for handling of 105lb motor
• Using the pallet the fan came on, place the motor in the center between
the pallet slats with the shaft facing up.
• Place housing over motor with the housings eyebolts aligning with motor
wiring ports as shown below.
• Use scrap wood 2x4’s or other items to lay between the pallet and
the fan housing to align motor brackets with motor and to support
the housing.
7
IS295-20H
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 5/12
Top
of
Fan
