IS295-21C J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 3/13
• Using
(28) 5/16”-18 x 7/8“
Bolts from Bag 2 (Part 1)
and (28) 5/16”
-18 Serrated Flange
Nuts from Bag 2 (Part 2)
, assemble the motor
mount brackets and venturi sections.
— Tighten only the bolts and nuts securing venturi sections.
— Holding the motor brackets up so the back side is flush to the
outside of the venturi sections, tighten the bolts and nuts
securing motor mounts and venturi sections.
2
Eye Bolt Installation:
• Stand the housing assembly up.
• Locate the dimple marks on the exterior of the venturi next to the motor
brackets.
• With a 13/64” drill bit drill out the (2) holes for the eyebolts.
3
