a. 1x Nut for
socket
b. 1x Washer
13. Tuners
a. 3x Left tuners
b. 3x Right tuners
c. 6x Mounting sleeve
14. 1x TOM-Style Bridge
a. 2x Drop-in Sleeve for TOM
b. 2x Insert for Drop-in Sleeve
15. 1x Stopbar Tailpiece
a. 2x Drop-in Sleeve for Stopbar
b. 2x Insert for Drop-in Sleeve
16. 2x Strap pin, Chrome
a. 2x Felt washer
17. 4x Neck mounting screws, 40mm
18. 2x Strap pin mounting screws, 29.8mm
19. 8x Humbucker frame screws, 17.5
mm
20. 10x Screws for covers, 12mm
21. 12x Screws for tuners, 10.5mm
22. 3x Truss Rod Cover screws, 8.8mm
23. Electric guitar string set
24. Allen key, 4 mm
Required tools:
•
Drill/cordless drill
•
Countersink, 12 mm
•
Wood drill bits, 1.5mm, 2mm and 4mm
•
Phillips screwdriver (small and medium)
•
Slotted screwdriver (medium)
•
Spanner, 10mm and 14mm
•
Rubber mallet
•
String cutter
•
Soldering iron and solder
Optional tools:
•
fret files and saddle files
•
Sand paper or chisel
•
Accessories for paint and finish (e.g. stain, cloth,
etc.)
Preparation: lacquer body and neck (optional)
Both the body and the neck are sanded ready to be painted at the factory, so that
oil- or wax-based stains as well as spray paint can be easily absorbed. As wood is a
natural material which expands or contracts under different temperature and
humidity conditions, it is recommended to seal the back of the body and neck with
a finish. All holes and routings for attachments and electronics, the neck pocket as
well as the fretboard and frets should be taped well beforehand with adhesive tape,
as an additional layer of varnish may prevent them from fitting properly.
ENGLISH
7
