DpuScan
Scamax 2600 / 5000
Scanner Options
5.2.6 Mode
The Mode is the summary of all settings and rules that will be described in the succeeding
paragraphs. Depending on the scanner, up to 16 modes can be loaded permanently into the driver.
During a scan job, one mode is selected, as seen in
Illustration 5 – Scanner Properties with Links to
the Patchcode Controlled Index
All succeeding settings work only for this selected mode, as shown in the title bar of the setup dialogs
in
on page
After these definitions, we refer to the configuration dialog, which appears when the corresponding
button is pressed in the scanner’s setup dialog.
5.3 Parameter
Configuration
The parameter dialog shows four tabs to set the Patchcode search options, the counter options, and
the endorser output. Below the pages there is a preview area to give the user an idea of the
endorser’s printout.
Placed on the right side of the dialog are buttons to save and reload the setting for this mode, and a
button labeled "Rules" that opens the "Control Configuration" dialog described later in this text (see
Chapter
Page 22 of 42
