Product Description
This exciting new J&M 2-channel 180w fairing speaker
amplifier kit has been design specifically for the universal
application 1998-2013 Harley® Batwing & RoadGlide
fairings, with the stock Harley or aftermarket radio system.
The less expensive universal application kit allows the
installer to configure or fabricate the exact mounting
location as desired, to meet their installation goals or space
requirements.
This is a full range class D amplifier and is spec’d at
90watts RMS per channel X2 channels, (180w total) driven
continuous into a 2 ohm load @ 14.4vdc.
Custom made plug-n-play wiring harnesses are included
with this amplifier kit, top quality heavy gauge power/ground
wires are used for the fused battery connection, along with
complete installation/operation instructions.
Amplifier itself measures 6 ½” X 4 ¾“ X 1 ¾”.
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (removal of the fuel tank is necessary for
proper installation)
3. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery. Then
connect the negative (black) lead from the power harness to
the same bolt/stud on the frame that the negative battery cable
is connected to. Then reconnect the negative battery cable to
the battery.
(Figure A)
Do not connect the negative (black) lead
from the amplifer to the negative post of the battery.
4. Mount the J&M amplifier in your desired location.
5. Make Amplifier/Speaker connections according to diagram.
(Figure B)
6. Test the system for proper operation before reassembling
the fairing, realizing that full sound quality and fidelity will not
be heard until the outer fairing shell is completely reinstalled.
BATT
+
Black
Red
Master Frame
Grounding Stud
Negative
Battery Cable
Fuse
Heavy Gauge
Amplifier Power/Ground
Wire Harness
Fig. A