8. Unplug the speaker wires from the speaker and set aside.
9. Remove the stock grill from the inner fairing by removing the 3
attachment screws.
VERY IMPORTANT:
Discard these screws as
they will not be used again.
(Figure D)
10. Install the new ‘J&M grills using the (3) #12 X ½” countersunk
self-tapping screws provided, with the grill-mounted tweeter in the
upright position.
VERY IMPORTANT:
Do Not use the stock Harley
screws to attach the new ‘J&M grills, or the speaker pods will not
reinstall properly.
11. Install the new 6.71” ROKKER XXR speaker using the original
speaker attachment screws; Ensure that the speaker is placed
into the pod with the tweeter-wire exiting to the upper, outer cor-
ner.
(Figure E)
12. Plug the tweeter wire from the speaker into the plug on the back-
side of the grill & then re-install the speaker pod assembly back
into the fairing.
13. Repeat steps 2 through 12 for the opposite side speaker.
Important Note: If the bike is equipped with the Harley CB radio
module, ensure that the CB module is removed before removing
the applicable speaker pod assembly.
14. Test each speaker for proper operation before reassembling the
fairing.
Fig. D
Fig. C
Remove screws
Remove screws
Fig. E
