![background image](http://html2.mh-extra.com/html/jandm/55-series/55-series_operators-manual_3080421012.webp)
12
L1
L1
L2
L2
L3
L4
Adjusting Running Gear Toe-In
•
Locate the tongue in the straight and horizontal position. Check this by measuring both “L1” locations. Once both
locations are the same length, move onto the next step.
• Measure both “L2” locations. Adjust both tie-rods to assure both measurments are equal, if necessary.
• Finish with taking measurments for “L3” and “L4.” L3 should be set 3/16” smaller than L4 by adjusting the tie-rods in
equal amounts.
• Measure both “L2” locations again. If both measurement are the same you are finished. If measurments are not the
same, repeat the entire process.
Tie-Rods
Summary of Contents for 55 Series
Page 13: ...13...