23
7. Bottom parts for coulters will be added in later steps.
8. The U-bolts for coulter 2 go through the slots in the weldment shown below. Continue to measure 50cm
across the tool bar to place coulters. Coulter 4 does not use a channel bracket plate. Instead, use (4) 5/8” x
3-1/2” hex bolts that go through holes in the toobar weldment to mount the channel bracket castings directly
to the weldment. Secure using 5/8” centerlock hex nuts.
9. Offset coulter mounts are used in areas or hinges that dont allow a direct mount. Coulter 6 and coulter 9 both
use an offset coulter mount. Offset coulter mounts use (2) 5/8”-11 x 7-1/8” x 8-11/16” square U-bolts with (2)
5/8” serrated flange hex nuts. Use (4) 5/8” x 3-1/2” hex bolts to mount the channel bracket castings to the offset
coulter mount and secure with 5/8” centerlock hex nuts.
2
4
3
5
{ {
50cm
50cm
6
9
8
7
{
{
{
{
50cm
50cm
50cm
50cm
Coulter Mounting - 50cm Row Spacing
