Jands HOG 1000 Operating Manual Download

Page: 106 / 126

100

••••

HOG – Version 3.20

Disks and Fixture Library

Are show disks recorded with early versions of software compatible with later versions of software?
Yes.

Are show disks recorded with later versions of software compatible with earlier versions of software?
Typically no.

In my library file, why does Douser = b still allow the channel to be controlled on the fader?
It is set as htp8bit. All HTP parameters are fader controlled.

How do I change fixtures so that they fade colour wheels?
Edit the fixture library for relevant fixtures: change crossfade = 1 under colour parameter to crossfade = 0.
You can also use the time window to over-ride on a cue by cue basis

Programming

I can’t see all the Beam parameters in the Programmer Time window.
Make sure that Beam has been selected in the Control Panel

Keep Parameters Separate

section.

I recorded a cue, but nothing appeared in the cue list.
Make sure the desired cuelist was chosen.

The

clear restore

button stays on even when programmer is cleared.

Make sure you've patched all your fixtures.

I have selected Cybers & VL5 groups. When I select a colour, the Cybers change, but VL5's don't.
You pressed a palette that only contained information for the Cybers.

My I-beams or Cybers will not respond to colour or gobo timing, even through I'm using the M
speed.
Make sure the fixtures are set to the correct personality setting.

I'm trying to create a palette with ICBF in it, but I only get colour (or focus or beam)?
Adjust the Masking settings while recording.

If I program colour mix channels, the colour wheel gets programmed as well, even though I didn’t
touch it.
All the colour parameters are linked; recording one records the others. You can unlink them by using the
control panel

Keep params separate

option. If you do unlink them, watch out! People usually

become confused by forgetting to touch all the wheels when recording looks.

My colour changer will not crossfade to the new colour even though I've put timing on the cue.
The colour parameter may be set to snap change in the fixture library. Either change it there or set the path
to 0.

If I change a cuelist on one page, will it change on the other pages.
Yes.

If I change the cuelist option settings, does this apply to all cuelists or just this one?
Just the one being changed. The options are specific to each cuelist. To change all, use the control panel

Cuelist defaults

function.

How can I copy a palette created for x amount of lights to another light if I decide to add it to the
patch afterwards.
When making the palette, make sure that you specify for one fixture only. All fixtures will then use this
value, as will all additional fixtures added later (of same kind).

How do I knock out individual parameters from a Q or a palette?
Load cue/palette, select the fixture, hold

Undo

, move the relevant parameter wheel, press

Update

ENTER

How do I remove fixtures from a cue?
Load the cue, select the fixtures, press

Knockout

, press

Update

How do I remove a fixture from a cuelist?
Select the fixtures to remove, press

Pig

and