Quick Start
••••
19
Record the Cue
Once a look has been created in the programmer it’s easy to record it as a cue. To record cue 1 on the first
Playback Master:
1
Press
Record
.
2
Press the
Choose
button above Playback Master number 1.
Playback the Cue
Press
Clear restore
to empty the programmer. Press the
GO
button above Playback Master 1. The
Halt
button stops playback. To clear a cue list on fader 1, first press fader 1’s
Choose
button to select it and
then press
Release
.
Setting up the Stage for XYZ Mode
Calibration
The XYZ system must first be calibrated before use. This process is simply a matter of aiming every fixture
at each of four calibration points. Accuracy is quite important, so you may want to iris down the fixtures
when aiming, if possible.
The map below shows the X and Y coordinates mapped onto a stage. Z is the height above the stage.
To calibrate fixtures:
Summary of Contents for HOG 1000
