USG-00000-JLXLITEMKII [1.0]
JLX LITE MKII
7
5. Depending on the required configuration it may be possible to install some of the wiring before
the bar has been hung. If this is the case, install any wiring that can be installed now.
6. Fit the JLX-LITE-MkII to the Perch Bar mount so that the bar slides over the integral spigot on
the mount. Ensure the bar slides all the way down and is resting against the mount. If the bar
does not rest against the mount, rectify the problem.
7. Fix the first JLX-LITE-MkII base to the supporting structure, checking the orientation of the
mains outlets.
8. If desired a second Perch Bar mount can be installed at the top of the bar to provide greater
stability.
9. Run and terminate the mains wiring. The Jands JLX-LITE-MkII is supplied as a wiring enclosure
for installation by a licensed electrician to AS/NZS 3000 - wire links are supplied to earth the
socket outlets to a nearby tab on the chassis. Bend the tabs inwards.
10. If using the ELV compartment, run and terminate the low voltage wiring, then fit / wire the con-
nectors.
11. Check the Earth continuity of all external parts and the socket outlet Earths.
12. Test the wiring as required by AS/NZS 3000.
13. Load test the bar.
14. Check the fixings are all in-tact and none have significantly deformed as a result of the load
test. At the same time double check all fasteners are secure and are using load spreading
washers. Also check there is an adequate quantity of fasteners (minimum one per bar hanger)
and the distribution of the fixings is even across the base/s. If necessary, add more fixings.
15. Cable tie the mains cable to the anchor points provided.
16. Cover any unused low voltage ELV connector knockouts with the supplied blank stick-on labels,
and similarly apply the numerical labels next to the mains sockets. Apply the numbers so they'll
be able to be seen through the cut-out in the dress cover when fitted - use the earth tab next to
the socket as a locating guide. Unused mains socket holes must be protected with a metal
cover.
17. Remove the clear protective coating from the covers.
18. Fit the covers. The covers must be secured using the screws provided.
19. Fit the supplied end plugs to any open ends of the bar.
20. Fill out the installation record.
