Jands Stage, Manual

7

Using Presets

Channel Preset Faders

There are two (2) rows of preset faders on the Stage 12/24. The top row of
faders is Preset 1 and the bottom row is Preset 2. These faders are used to
set lights to desired levels. The output level produced by the Preset faders is
dependent on the level of the P1 (or P2) Master fader.

Example:-

-  Bring the P1 Master faders to 10 (100%).
-  Move the Channel 1 Preset fader to 100% and you should see the lights
   connected to that channel fade up to full level.
-  Now fade up Channel 2 to 5 (50%) and check that the lights connected
   to Channel 2 are at about 1/2 level.
-  Finally fade the P1 Master down and Up to see how it scales the
   Channel Preset faders.

Doubling Number of Channels

Using all Preset faders as a single preset to obtain double the number of
channels. (See Page 11) To double number of channels by using the console
in a single preset bank mode

Channel Flash Buttons

These buttons correspond to the Channel faders and perform two functions:

1

Flash. The buttons are used to momentarily flash on a channel. The type
of operation (add, solo) of the flash button depends on the setting of the
Add / Solo master switch.  See page 8.

2

Chase Assign. Pressing the Asn button puts the Stage 12/24 into chase
assign mode, indicated by the LED in the Asn button being on. See Page
9.