Page 8
Figure 7. Filter Clamp Ring Assembly
"T" Nut
Thread ed
Rod
Tightening
Nut w/
Shoulder
Clamp Ring,
Closed Position
GAP NOT TO EXCEED
1/16"
Figure 6. Filter Clamp Ring
Clamp
Ring
Tightening
Nut w/
Shoulder
Use a 9/16" Socket
Clamp Ring
“T” Nut and
Threaded Rod
Tightening Nut
w/ Shoulder
WARNING
NEVER
operate the
fi
lter system at more
than 50 psi of pressure. Operating
fi
lter
system in excess of 50 psi can cause
product failure or also cause the
fi
lter lid to
be blown off, which can cause death, seri-
ous personal injury or property damage.
WARNING
Changing the two (2) or three (3) port diverter valve
handle while there is pressurized air in the system
can cause product failure or also cause the
fi
lter
lid to be blown off, which can cause death, se ri ous
personal injury or property damage.
Caution
Dust released during normal handling of diatomaceous
earth can cause eye and respiratory irritation. Prolonged
breathing of excess concentrations of dust may cause
lung damage.
Caution
Never
operate the
fi
lter in excess of three (3)
minutes without use of diatomaceous earth (DE). DE
is the substance that
fi
lters the water, the
fi
lter cloth
merely supports the DE. Operating without DE will
damage
fi
lter grids and short en
fi
ltering cycles.
Caution
DO NOT
operate the
fi
lter at water temperatures
above 105° F (40.6° C). Water temperatures above
the manufacturer's recommendations will shorten the
life span of the
fi
lter and void the warranty.
5. After
the
fi
rst week of operation, check the
clamp and retighten if necessary.
6. Check
the
fi
lter clamp at least once a month.
Section 4. Start-Up and Operation
4.1 Preparing Diatomaceous Earth
Your
fi
lter requires diatomaceous earth (DE) for
proper
fi
ltration and operation. The
fi
lter grids must
be precoated with DE in order to protect their sur-
faces and provide the most ef
fi
cient
fi
ltering action.
Refer to Table 2 for the proper quantity of DE to use
with your
fi
lter.
1.
Using a one (1) pound coffee can,
fi
ll the can
with diatomaceous earth (DE). Do not pack or
compress the DE into the can.
2.
Mix the required amount of DE with suf
fi
cient
water in a separate bucket to make a thin, milky
mixture (slurry).
NOTE
Excess DE will clog the system. Use amount
speci
fi
ed in this manual.
3.
Use the following instructions to coat the
fi
lter
grids.