Jandy ePump, Installation Manual

Page 11

3.5.4 

Timer Overriding a Manual On

If the pump is started manually at a speed that has been 
programmed with a timer, the pump will be stopped by the 
timeclock at the programmed off time. A clock icon appears 
on the display when the timer has assumed control of the off 

time.

Section 4. Service Setup Options

The service setup menu allows the installer to set various 
operating parameters, view fault history, and restore factory 
defaults.

Parameters that may be modified and set in the service setup 
menu include:

Priming speed and duration.

•

Minimum and maximum pump speeds.

•

"

•

œ

" eStar speed.

Pump Freeze Protect operation.

•

4.1 

Entering Service Setup

NOTE 

The ePump

TM

 user interface must be in the 

OFF

mode (all LED's lights must be off) before entering 
the user setup mode. While in setup mode the user 
interface will return back to the 

OFF

 mode after one 

(1) minute since the last key press.

To enter the service setup menu, press and hold 

MENU

, then 

press and hold the "

œ

" and preset "4" keys. Hold all three 

(3) keys down for five (5) seconds. To exit, press any preset 
button.

2

3

4

ePUMP

MENU

PRESS PRESET OR MENU

12:00AM         PUMP IS OFF

4.2 

Minimum and Maximum Pump 
Speeds

These speeds are considered global settings across the entire 
controller, and create the range of allowable speed that may 
be sent to the ePump™.

To set the minimum speed, from the service setup menu, 
select 

SET MIN LIMIT

 using the arrow keys. Press 

MENU

. 

Using the arrow keys, set the minimum speed to the desired 
value. Press 

MENU

 to accept and store.

2

3

4

SET MIN LIMIT
                            RPM: 600

ePUMP

MENU

To set the maximum speed, from the service setup menu, 
select 

SET MAX LIMIT

 using the arrow keys. Press 

MENU

. 

Using the arrow keys, set the maximum speed to the desired 
value. Press 

MENU

 to accept and store.

2

3

4

SET MAX LIMIT
                           RPM: 3450

ePUMP

MENU

4.3 Load 

Defaults

To restore factory default settings to the controller, from 
the service setup menu, select 

LOAD DEFAULTS

. Press 

MENU

. Using the arrow keys, select 

YES

. Press 

MENU

 to 

restore factory default settings.

2

3

4

LOAD DEFAULTS
                             YES

ePUMP

MENU