Zodiac Pool Systems LLC
2882 Whiptail Loop # 100, Carlsbad, CA 92010
1.800.822.7933 | Jandy.com
Zodiac Pool Systems Canada, Inc.
3365 Mainway, Unit 2
Burlington, ON L7M 1A6
1.888.647.4004 | Jandy.ca
©2021 Zodiac Pool Systems LLC. All rights reserved.
ZODIAC
®
is a registered trademark of Zodiac International, S.A.S.U.used under license.
All other trademarks are the property of their respective owners.
H0667000_REVD
Problem
Possible Cause
Corrective Action
Lights don’t turn on
Lights are not
powered
Check the 120VAC power
supply into the transformer,
14VAC output at the
transformer, and ensure
the lights are enabled via
the iAquaLink app. Check
or reset the GFCI. Make
sure 120 volts has not been
used in the installation. If so,
damage is assured and is
not warrantable.
One or more lights are
dim, blinking or not
working
Poor connection or
improper wire gauge
Separate each light and
independently wire 14VAC
to a single light only. Repeat
this process for each light.
If the junction box is being
used, then check for proper
connection of the light
cord. Verify that the correct
wire gauge is being used
between the transformer and
junction box.
Lights are flashing
yellow
Lights are not
communicating with
the Infinite
WaterColors LED
Light Controller or
lights are connected
to a non-compatible
controller or
transformer.
Confirm lights are powered
by the Infinite WaterColors
LED Light Controller. If
not, then connect and try
again. If they’re powered,
then check the RS-485
connection.
Different colors from
different lights
Zones are set
differently
Check that lights are in the
same zone, or that all zones
are set to the same color.
ETL LISTED
CONFORMS TO
UL STD 676
CERTIFIED TO
CAN/CSA C22.2 NO.89
