Page 8
ENGLISH
Jandy
®
Infinite WaterColors
™
Nicheless LED Light | Owner’s Manual
14 VAC Class 2 Magnetic
Transformer or
Junction Box
48” min.
Check AHJ for other J-box requirements
8” minimum to maximum water level
1.5” pipe. Length requirement varies
by model. (See Table 1)
Rigid 1” electrical conduit. Sweep
elbows only, no 90º elbows.
NOTE: Vertical installations such as bench and walk-out locations will use ALL of the same clearance requirements.
The light face must be completely snug with the light fitting without any protrusion from the light fixture.
4” minimum to top of lens
Maximum possible water line.
(top of copping)
Figure 1.
Jandy
®
LED Light Installation with Standard 1.5” Plastic Fitting
Use the chart below to determine the appropriate pipe length for your
installation.
WATTS
MINIMUM LENGTH FOR 1.5” PIPE
15W
10”
Cord length options: 100ft and 200ft
Table 1.
Jandy
®
LED Light Minimum 1.5” pipe length
3.2 Installing the Light Fixture
NOTE:
Perform these steps
only
after the electrical system requirements are met.
1. Keep protective cover on to protect the light during installation.
The light face must be completely
snug with the return fitting without
any protrusion from the light fixture.
NOTE: Gasket helps ensure
that the conduit is not a
potential leak path.
See Table 1
for min. length
requirements
Figure 2.
Standard installation with 1.5” pool wall fitting
