Page 7
Section 2. System Description
2.1 Product Description
The PureLink System is an all-in-one, Chlorine Generator and Control System Power Center and Cell Kit
for use with AquaLink RS PDA, All Button, or OneTouch controllers.
ATTENTION INSTALLER:
Various application notes (including more detailed
instructions) are available from the Dealer covering installation, operation,
maintenance, and plumbing of the chlorinator system.
Figure 1.
Typical PureLink Installation With Options
AquaPure
Pump
Filter
AquaLink RS
PureLink
Power Center
Flow/Salinity Sensor
Cell
Heater
Spa Intake
Pool Intake
Spa Return
Pool Return
Options List
1. ORP/External Control Interface
2. ORP/Freeze Control Unit
3. Heater
ORP Unit
(Control Signal from ORP Unit to
ORP Interface/Aux Board)
The PureLink Power Center and Cell Kit uses a process known as electrolysis to produce sodium
hypochlorite (liquid chlorine) from a low concentration of salt added to the pool water. Hypochlorite kills
bacteria, oxidizes organic material, and kills algae then reverts back to salt. The PureLink then reuses the
salt and the process starts over again. The PureLink system is comprised of the following three component
parts.
Power Center
The AquaLink RS PureLink Power Center converts AC electrical current to a low
voltage DC current which is required by the cell to perform the electrolysis. The
power center is connected with the pool circulation pump electrical source so that
the electrolytic cell only operates when the pool pump is on. The flow portion of the
Flow/Temp/Salinity Sensor
is a backup device only.
Detail A
Detail B
Detail C
Preferred
Not Preferred
Hazardous
