SECTION 2.
General Information
2A. Introduction
This manual contains information for the proper
installation and operation of Jandy Ray-Vac Automatic
Pool Cleaners. Procedures in this manual must be
followed exactly. To obtain additional copies of this
manual contact us at 707-776-8200, ext. 237. For
address information see back cover.
The Ray-Vac Pool Cleaner requires either (1) an
operable booster pump installed in the pool circulation
system: or (2) the pool circulation system plumbed per
Jandy installation instructions for non-booster pump
applications. If you are uncertain if the pool meets one
of the above requirements, consult your local pool
professional.
SECTION 3.
Wall Mounting Location
3A. Pool Cleaner Line
1.
The pool cleaner line should be located on the
"clean wall" (no obstacles such as steps, love
seats, ladders, etc.).
2.
The location should also be equidistant from the
furthest points of the pool (see Fig. 1).
3.
Position the pool cleaner so that it will be 6" to 8"
below the normal water level of the pool.
Page 2
Figure 2. Ray-Vac Hose in Pool
6" to 8"
SECTION 4.
Head and Hose Installation
4A. Attaching Ray-Vac Head to Hose
1.
Unpackage and lay out hoses. Locate Ray-Vac
pool cleaner head. Locate package of lettered
reducer washers (Booster Pump Kit).
Note:
The washers are for use with booster pump
cleaner only. Do not use for non-booster pump
installation.
2.
Insert barbed end of pusher jet into silicon hose
on Ray-Vac head. Be sure silicone hose
completely covers barb and is on straight
(see Fig. 3).
Ray-Vac
Head
Silicon
Hose
Pusher Jet
& Hose
Figure 3. Attaching Pusher Jet Hose to Ray-Vac Head
Push Hose
On To Here
Figure 1. Pool Cleaner Line Location
A
B
A and B are Equal Lengths