54
GridVis
®
Collector
www.janitza.de
www.janitza.de
GridVis
®
Collector
make sure that the IP addresses of the on-site mea-
surement devices (e.g. transformer station) are in the
same range. Otherwise, reconfigure the IP addresses in
the GridVis
®
Collector (device mode) for each measure-
ment device to be read out.
Example "Assignment of IP addresses"
· The computer with the GridVis software installed
has the IP address 192.168.1.234 in the server
network.
· The GridVis
®
Collector (server mode) has the IP ad-
dress 192.168.1.100 in the server network (network
of the computer with GridVis software installed).
· The GridVis
®
Collector (device mode) has the IP
address 192.168.5.254 at the measurement device
on site.
In this example, the on-site measurement devices (e.g.
transformer station) could be assigned IP addresses in
the range from 192.168.5.1 to 192.168.5.253.
All on-site measurement devices that are not connec-
ted to a switch can be given the same IP address. The
GridVis
®
Collector recognizes the measurement devices
by their serial numbers.
6. 3 Assigning measurement devices to the
GridVis
®
Collector in the GridVis software
After the IP address configuration of the on-site mea-
surement devices, register the GridVis
®
Collector in the
GridVis software.
Afterwards, measurement devices from your GridVis
project can be assigned to the GridVis Collector in the
GridVis software.
Summary of Contents for GridVis Collector
