16
Winding a Bobbin
q
Thread guide bar
w
Bobbin winding tension disk
e
Bobbin hole
r
Notch
t
Spring
y
Bobbin winder spindle
u
Bobbin winder stopper
i
Bobbin winding button
z
Pass the thread through the guide on the
thread guide bar
q
from behind.
x
Pass the thread under the bobbin winding
tension disk
w
.
c
Thread through the hole
e
in the bobbin from
the inside to the outside.
Match the notch
r
with the spring
t
on the
bobbin winder spindle. Then insert the bobbin
on the bobbin winder spindle
y
.
v
Push the bobbin winder stopper to the left
u
.
b
Hold the free end of the thread in your hand
and press the bobbin winding button
i
. Press
the bobbin winding button again to stop the
bobbin when it has made several turns, and
cut the thread close to the hole in the bobbin.
n
Press the bobbin winding button again. When
the bobbin is fully wound, the machine will
stop automatically.
Return the bobbin winder stopper to its
original position. Cut the thread with a
scissors. Remove the bobbin from the bobbin
winder spindle.
z
x
c
v
b
n
NOTE:
This machine has an exclusive motor for bobbin
winding, which allows you to wind a bobbin while
stitching.
q
w
e
r
t
y
u
i
Pull the thread guide bar up as
far as it will go. Turn the thread
guide bar until the stoppers
click into position.
A: Stopper
