Janome 1600P series, Instruction Book

5

Up/Down Needle Position Button

3

RED LED

GREEN LED

Press this button to bring the needle bar up or
down. The RED LED will light up when the needle
is down. The GREEN LED will light up when the
needle is up.
The machine will stop with the needle up or down
depending on the needle position determined by
this button.
The machine will always stop with the needle up
after auto thread cutting or buttonhole sewing.

Press this button to wind the bobbin.
The LED will light up when you shift the bobbin
winding stopper toward the bobbin and press this
button.
The LED signal will turn off after bobbin winding is
finished.

LED

Bobbin Winding Button

Thread Cutter Button

*Model 1600P and 1600-DBX only

Pressing this button after sewing will trim the
threads.
You can continue sewing without pulling the bobbin
thread up after trimming the threads.

* Use the thread cutter on the face cover if the

thread is thicker than #30.

* The foot control and Up/down needle position

button cannot be used while the machine is
trimming the threads.

Stitch Length Adjustment Dial

You can adjust the stitch length from 0 to 6 mm by
turning this dial. The stitch length will be show on
the stitch length display 

q

.

Reverse Stitch Lever

The machine will sew in reverse while the reverse
stitch lever is pressed down. The machine will sew
forward if the lever is released.
Use the lever to lock the beginning and end of
seams.

q