8
Presser Foot Lifter
The presser foot lifter
q
raises and lowers the presser
foot.
You can raise the foot about 1/4
˝
(0.6 cm) higher than the
normal up position
w
for easy removal of the presser
foot, or to help you place thick material under the foot.
q
Presser foot lifter
w
Normal up position
e
Highest position
q
w
e
w
e
Removing and Attaching the Foot Holder
q
w
e
w
q
z
x
Changing the Presser Foot
q
w
e
• Removing the foot holder
Remove the setscrew
q
by turning it counterclockwise
with a screwdriver.
• Attaching the foot holder
Match the hole in the foot holder
w
with the threaded
hole in the presser bar
e
. Fit the setscrew
q
into
the hole. Tighten the setscrew
q
by turning it clockwise
with a screwdriver.
q
Setscrew
w
Foot holder
e
Presser bar
CAUTION:
Turn OFF the power switch before changing the foot .
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
• Removing the presser foot
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot,
and press the lever
q
on the back of the foot holder.
• Attaching the presser foot
Place the selected presser foot so that the pin
e
on
the foot lies just under the groove
w
on the foot
holder. Lower the presser bar to lock the foot into
the place.
q
Lever
w
Groove
e
Pin
CAUTION:
Turn OFF the power switch before detaching or
attaching foot holder.
Summary of Contents for 2030DC-T
Page 1: ...INSTRUCTION BOOK...
Page 44: ...808 800 202 t EN...
