AAASewing.com
12
Adjustment of Cutting Width
When cutting width is too narrow or too wide against
seam width, adjust it as follows.
[1] Turn off the power switch and unplug the
machine.
[2] Open the looper cover and side cover.
[3] Set the upper knife to down position
[4] Turn the cutting width adjusting dial to get
desired position of lower knife.
1
Cutting width adjusting dial
2
Lower knife
3
Standard setting
* The cutting width of this model can be
adjusted approximately 3.0 to 5.0 mm from the
right needle position depending upon your
sewing needs or the fabric being used.
(The cutting width should be adjusted to get
the same results as in drawing 3.)
(A) When cutting width is too narrow.
Turn cutting width adjusting dial clockwise.
Lower knife will move to right.
(B)
When cutting width is too wide.
Turn the cutting width adjusting dial
counterclockwise.
Lower knife will move to left.
[5] Set the upper knife to up position.
[6] Close the looper cover and side cover.
1
2
2
3
2
2
(A)
(B)
Janome 204D Instruction Manual
Janome 204D serger
www.aaasewing.com
204D Owners Manual/ User Guide
