10
A
C
B
A
TO CHECK:
1. RAISE THE PRESSER FOOT LEVER (B).
2. THE DISTANCE BETWEEN THE PRESSER FOOT (A) AND THE NEEDLE PLATE (C) SHOULD BE
6.0 MM (0.24”).
IF THIS IS NOT THE CASE, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1. REMOVE THE FACE COVER. RAISE THE PRESSER FOOT LEVER (B) AND LOOSEN THE
SETSCREW (D) ON THE PRESSER BAR HOLDER (E).
ADJUST THE DISTANCE BETWEEN THE PRESSER FOOT AND THE NEEDLE PLATE TO 6.0 MM
(0.24”).
2. TIGHTEN THE SETSCREW (D) SECURELY.
3. ATTACH THE FACE COVER.
PRESSER FOOT LEVER (B)
SETSCREW 4 X 8 (D)
SHOULD BE PARALLEL
FEED DOG SLITS (F)
NOTE:
WHEN YOU TIGHTEN THE SETSCREW, MAKE SURE THAT BOTH SIDES OF THE PRESSER FOOT ARE
PARALLEL TO THE FEED DOG SLOTS (F) ON THE NEEDLE PLATE.
<PRESSER FOOT ALIGNMENT>
FEED DOG
<HEIGHT OF PRESSER FOOT>
N E E D L E
PLATE (C)
PRESSER FOOT (A)
PRESSER BAR HOLDER (E)
6.0 mm
MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT AND ALLIGNMENT
