14
MECHANICAL ADJUSTMENT
FEED DOG HEIGHT
TO CHECK:
1.
LOWER THE PRESSER FOOT.
2.
TURN THE HANDWHEEL TOWARD YOU TO BRING THE FEED DOG TO ITS HEIGHEST
POSITION. THE HEIGHT OF THE FEED DOG FROM THE NEEDLE PLATE SHOULD BE
0.75 TO 0.90 MM.
IF IT IS NOT IN THE RANGE, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1.
REMOVE THE BASE (SEE PAGE 5).
2.
LOWER THE PRESSER FOOT AND TURN THE HANDWHEEL TOWARD YOU UNTIL THE
FEED DOG COMES TO ITS HIGHEST POINT.
3.
LOOSEN THE SCREW (A) .
4.
TURN THE FEED LIFTING PIN TO ADJUST THE HEIGHT OF FEED DOG (0.75–0.90 MM).
5.
TIGHTEN THE SCREW (A).
6.
TURN THE HANDWHEEL TOWARD YOU TO RECHECK THE HEIGHT OF FEED DOG.
7.
ATTACH THE BASE.
0.75 TO 0.90MM
NEEDLE PLATE
(A)
FEED LIFTING PIN
Summary of Contents for 415
