10
Drawing Up Bobbin Thread
1
Raise the presser foot and hold the needle thread
lightly with your left hand.
2
Turn the handwheel one complete turn toward you
and raise the needle to its highest position.
Pull the needle thread to pick up a loop of the bobbin
thread.
3
Pull 15 cm (6") of both threads back and under the
presser foot.
1
2
3
Needle Threader
1
2
3 4
1
Raise the needle to its highest position.
Press down the needle threader knob as far as it will go.
The hook comes out through the needle eye from behind.
2 Pull the thread down around the thread guide then pass
it from the left and under the hook.
3 Release the knob slowly while holding the thread end
with your hand.
A loop of the thread is pulled up through the needle eye.
4 Remove the loop from the threader and pull out the
thread end from the needle eye.
Note:
The needle threader can be used with a #11/75
to #16/100 needle or Janome Blue Tipped needle.
Thread size 50 to 100 would work well.
Caution:
Be sure to raise the needle to its highest
position when using the needle threader,
otherwise the hook will miss the needle eye
and will be damaged.
Summary of Contents for 419S
Page 1: ...Models 419S 423S...
Page 34: ...Printed in Taiwan 303 800 051...
