Janome 5030, Service Manual

20

CORRECT CONDiTiON

sTEP AND 

iTEMs TO 

CHECk

05)

PREssER 

FOOT 

liFTER 

sWiTCH

PROCEDuRE

DEFECTiVE CONDiTiON

Turn the handwheel toward you. 
Lower the needle bar from its 
highest to lowest position.
Raise the needle bar from its 
lowest position to highest 
position.
If the result is correct condition, 
press the start/stop button to 
proceed the next step.
If the result is defective condition, 
press the reverse stitch button to 
proceed the next step.

Buzzer does not sound.
Stitch width or length 
symbol does not appear.

–REMEDy–
Replace the circuit board P.
Replace the circuit board A.

Zigzag motor does not get 

default position.

buzzer does not sound.

–REMEDy–

Replace the zigzag motor.

Replace the circuit board A.

Feed motor does not get 
default position.
buzzer does not sound.

–REMEDy–
Replace the feed motor.
Replace the circuit board A.

06)

uPPER sHAFT 

POsiTiONiNg 

sENsOR

07)

zigzAg MOTOR

(sTEP MOTOR)

AND

FEED MOTOR

Turn the handwheel toward you.
Lower the needle bar its highest 
to position (zigzag phase).
Press the needle up/down button.
Raise the needle bar from its 
lowest position to its highest 
position (feed phase).
Press the needle up/down button.
If the result is correct condition, 
press the start/stop button to 
proceed the next step.
If the result is defective condition, 
press the reverse stitch button to 
proceed the next step.

LCD displays “SC 06--”.

Turn the handwheel. 
LCD displays stitch width symbol 
when the needle bar is at zigzag 
phase.

LCD displays “SC 07--”.

Press the needle up/down button 
when LCD displays stitch width  
symbol. 
The Zigzag motor will be initialized 
and get its default position.

sElF-DiAgNOsTiC TEsT

Not applicable for this machine.
Press the start/stop button to 

proceed the next step.

LCD displays “SC 05--” and presser 
foot symbol.

Presser 
foot  
symbol

Press the needle up/down button 
when LCD displays stitch length  
symbol. 
The feed motor will be initialized and 
get its default position.

Stitch 
width 
symbol

Stitch 
length 
symbol

LCD displays stitch length symbol 
when the needle bar is at feed phase.

Stitch 
width 
symbol

Stitch 
length 
symbol