24
MECHANICAL ADJUSTMENT
THREAD CUTTER
The distance between the end of thread cutter plate slit and the edge of moving cutter should be in the range of
0.9 to 1.3 mm.
To check:
1. Remove the free arm cover (see page 5).
2. Turn the power switch off. Slide the moving cutter to the right with your finger.
3. Turn the power switch on.
The moving cutter motor is initialized, and moving cutter moves to its home position automatically.
4. The distance between the edge of moving cutter and the end of thread cutter plate slit should be 0.9 to 1.3
mm.
If not, follow the procedure below.
To adjust:
5. Loosen the setscrew on the sensor plate.
6. Adjust the distance between the end of thread cutter plate slit and the edge of moving cutter to 1.1 mm by
moving the sensor plate in the direction of A or B.
Moving cutter
0.9 to 1.3 mm
Sensor plate
D
E
Setscrew
Thread cutter switch
End of thread cutter plate slit
Edge of moving cutter
Summary of Contents for 5270QDC
Page 1: ...First Edition 06 March 2020 SERVICE MANUAL PARTS LIST MODEL 5270QDC For Europe only...
Page 39: ...37 TOUCH PANEL KEY POSITION ADJUSTMENT GUIDE Print this illustration guide to its actual size...
Page 52: ...50 MODEL 5270QDC PARTS LIST 1 2 3 4 6 5 7 8 9 10 11 12 13 14 17 15 18 19 20 9 21 21 22 23 16...
