68
Adjusting Stretch Stitch Balance
The sewing results of the stretch stitch patterns may
vary depending upon the sewing conditions, such as
sewing speed, type of the fabric, number of layers, etc.
Always make test sewing on a scrap piece of the
fabric that you wish to use.
q
Stretch stitch balancing dial
w
Standard setting mark
e
Groove
Example: (Stitch pattern )
(A)If the pattern is compressed, turn the stretch stitch
balancing dial in the direction of “+”.
(C)If the pattern is drawn out, turn the stretch stitch
balancing dial in the direction of “–”.
NOTE:
In normal sewing, set the dial to the neutral position,
i.e. the groove on the dial is centered with the
standard setting mark.
q
w
e
(A)
(B)
(C)
q
w
e
r
t
i
t
u
y
WARNINGS:
Turn OFF the power before replacing the light bulb.
The bulb could be HOT, wait until it has cooled
down before touching it.
• To remove:
Remove the cap and setscrew on the faceplate.
Disengage the tabs from the back panel to remove
the face plate.
Pull out the bulb from the socket.
• To replace:
Insert the bulb into the opening of the socket.
Attach the face plate engaging the tabs with the slots
on the back panel.
Tighten the setscrew and attach the cap.
q
Cap
w
Setscrew
e
Back panel
r
Hook
t
Face plate
y
Light bulb
u
Lamp socket
i
Tabs
NOTE:
Replace the bulb with the same type rated 12V, 5W.
Always refer the part number #000026002 when
ordering a replacement bulb.
SECTION 5. CARE OF YOUR MACHINE
Replacing the Light Bulb
