18
990D
Correct Setting:
When the needle plate setting knob is set at "S", the chaining finger should touch the side of needle
plate, and the tip of the chaining finger should be same level with the tip of the needle on the
needle plate.
To adjust:
1. Remove the presser foot.
2. Set the needle plate setting knob to guide line S on chaining finger unit.
3. Loosen the setscrews A, and move the chaining finger unit to correct position.
4. Tighten two setscrerws A.
5. Set the needle plate setting knob to "S" and "R" on the chaining finger unit, and check the
position of chaining finger.
6. Attach the presser foot.
TO ADJUST THE POSITION OF THE CHAINING FINGER
