18
1 Holder 2 Arrow 3 Needle thread
4 "Y" Groove 5 "V" Groove
3
4, 5, 6
7, 8
7 Needle bar thread guide
8 Right needle
3 Thread tension unit
How to Use Needle Threader
1
Hold the threader in your right hand with
the “V” groove and arrow facing toward you.
2
With the thread in your left hand place the
thread in the “Y” groove and turn needle threader
once clockwise to place the “V” groove
and arrow facing up.
3
Holding the thread in your left hand, gently slide
the needle threader down the needle while at
the same time placing enough pressure on the
threader to ensure the inside pin meets the eye
of the needle.
4
Push the pin through the needle eye forming
a thread loop.
5
Remove the threader and draw the loop towards
the back of the needle.
Turn off the power switch before using the
needle threader.
3
5
6
4
7
2
3
4
5
1
3 Hold the thread at both ends and tug gently
to ensure the thread is correctly inserted in the
thread tension unit.
4, 5
Pass the thread under the right needle thread
guide, then, pull it up and over the right take-
up lever cover.
6 Pass the thread through the needle
thread guide.
7 Raise the needle bar to its highest point by
turning the handwheel toward you then
thread the needle bar thread guide.
8 Pull out the thread 10 cm (4”) after threading
the right needle.
8
1, 2
3, 4
5
4 Right needle thread guide
5 Right take-up lever cover
6 Needle thread guide
Summary of Contents for CompuLock
Page 1: ...INSTRUCTION BOOK CompuLock...
