34
8. OVERLOCK 5
Needle setting position: LF (left front)
RB (right back)
The threading procedure is as follows:
1 Lower looper thread
2 Upper looper thread
3 Double chain looper thread
4 Left needle thread (LF)
5 Place a sewing test piece under the needle
and lower the presser foot.
6 Turn the handweel toward you and sew 2 to
3 stitches and pull the sewing test piece so
that the double chain looper
thread comes out of the needle plate hole.
7 Thread the right needle thread , then place it
under the presser foot together with the right
needle thread and double chain looper
threads.
* Make it easier to begin sewing...
Cut the fabric as shown so that the presser
foot can be placed beside the fabric, then
sew 2-3 stitches by turning the handwheel.
When you start sewing the next piece of fab-
ric, the thread chain is already made so that
you don’t need to cut the corner of fabric.
1
2
3 cm (1.2’’)
Cut off
3
4
Upper knife
Cutting line
1
2
3
4
8
Summary of Contents for CompuLock
Page 1: ...INSTRUCTION BOOK CompuLock...
