123
Troubleshooting (Automatic Needle Threader)
If the automatic needle threader is stuck and will not
return to the up position automatically, correct it as
follows:
Carefully turn the handwheel away from you or toward
you to move the needle up a little. The automatic needle
threader will return to the up position automatically.
If the automatic needle threader still does not return to
the up position, follow the steps below.
z
Turn the power switch off.
Open the face plate.
x
Lift the shaft plate with your finger as far as it goes.
c
Close the face plate.
Turn the power switch on.
z
x
c
