JanomeFlyer.com
32
4
4
3
4
4
3
4
4
3
q
w
e
q
w
r
e
q
w
e
q
w
e
(A)
(B)
Balancing the thread tension
z
Set the tension dials as follows:
For narrow-left (3 mm wide):
q
Left needle thread tension dial:
4
w
Center needle thread tension dial:
4
e
Looper thread tension dial:
3
For narrow-right (3 mm wide):
q
Center needle thread tension dial:
4
w
Right needle thread tension dial:
4
e
Looper thread tension dial:
3
For Wide (6 mm wide):
q
Left needle thread tension dial:
4
w
Right needle thread tension dial:
4
e
Looper thread tension dial:
3
x
Check the tension balance by test stitching on the
same fabric and threads as actual garment.
Fine-tune the tension as necessary.
Balanced tension:
The rows of stitches on the right side of the fabric are
straight and even. The looper thread forms a row of
squares with diagonals.
q
Wrong side of the fabric
w
Looper thread
e
Left needle thread
r
Right needle thread
(A) If the needle thread tension is too loose:
– The stitches on the right side are irregular and loose.
– There is a gap between head and tail of the looper
thread crossing points.
Tighten the needle thread tension, and/or loosen the
looper thread tension to correct it.
(B) If the needle thread tension is too tight:
– The fabric puckers.
Loosen the needle thread tension, and/or tighten the
looper thread tension to correct it.
Janome CoverPro 1000CPX Instruction Manual
www.janomeflyer.com
1000CPX Owners Manual/ User Guide
