20
Winding the Bobbin
Removing the bobbin
Slide the hook cover release button to the right, and
remove the hook cover.
Lift the bobbin out.
q
Hook cover release button
w
Hook cover
e
Bobbin
Setting the spool of thread
Place the spool of thread on the spool pin with the
thread coming off the spool as shown.
• For an ordinary spool:
Use the large spool holder.
q
Large spool holder
• For a narrow or small spool:
Use the small spool holder.
w
Small spool holder
• Additional spool pin
The additional spool pin is for bobbin winding, without
unthreading the machine, and for twin needle sewing.
Set the spool stand under the additional spool pin,
place the felt, then insert into the hole.
q
Spool
w
Additional spool pin
e
Felt
r
Spool stand
t
Hole for the additional spool pin
Winding the bobbin
NOTE:
Set the speed control lever at for bobbin winding.
z
Guide the thread around the bobbin winder thread
guide.
q
Bobbin winder thread guide
x
Insert the thread through the hole on the bobbin,
threading from the inside to the outside. Put the
bobbin on the bobbin winder spindle.
w
Bobbin winder spindle
c
Push the bobbin winder spindle to the right. The
LED display shows .
v
With the free end of the thread held in your hand,
depress the foot control. Stop the machine when
the bobbin has made a few turns, and cut the
thread close to the hole on the bobbin.
b
Depress the foot control again. When the bobbin is
fully wound, it will stop automatically. Return the
bobbin to its original position by moving the spindle
to the left, and cut the thread as shown.
q
w
e
q
w
q
w
e
r
t
z
x
x
c
v
b
q
w
