JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
148
the Object Details dialog. Change these settings
before or after applying the effect. See
Adjusting
Feather Edge settings
for details.
To apply Feather Edge
Click the
Feather Edge
icon.
The effect is applied to new or selected objects, based
on the current
Feather Edge
settings.
Click
Feather Edge
again to remove the effect.
Adjusting Feather Edge settings
Adjust the Feather Edge settings to change the
amount of feathering, the side of the object to
which the effect is applied and the margin in which
the stitches should fall.
To adjust Feather Edge settings
1
Select and double-click the object.
The
Object Details
dialog opens.
2
Select the
Feathering
tab.
3
Select the
Feathered
checkbox.
4
Enter a
Maximum Width
for the feathering, this is the
margin in which the stitches will fall.
5
Use the
Raggedness
slider to indicate the required
degree of texture:
left for a smooth texture
right for a rough texture.
6
Select the
Feathered Side
checkbox you require: left
or right or both.
7
Click
OK
.
Click Edit > Feather Edge to apply the effect to
new or selected objects.
Range
Max. Width: 0.5mm
Max. Width: 3.0mm
Raggedness: Low: less
variation in stitch length
Raggedness: High: more
variation in stitch length
Summary of Contents for Digitizer MB
Page 236: ...234 Part IX Software Feature Table...
