JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
206
Writing to Flash Memory reader/writer
If you are using an external ‘Flash Memory’
(ATA PC) reader/writer, you can write designs in
JEF format directly to card. Make sure the
reader/writer is securely plugged into the USB port
of your PC. If you are writing to a card intended for
use with an MC11000 machine, make sure this is
selected as your current machine. After writing
your design, simply insert the card into the ATA PC
card slot on your machine and read in the design.
See also
Supported machine models and memory
cards
.
Writing a design to ATA PC card
The procedure for writing a single design to Flash
Memory reader/writer is essentially the same as
sending a single design file to machine except that
you click the Write to Card icon or select
External Media > Write a Design. See
Sending
the current design to machine
for details.
Writing multiple designs to ATA PC card
The procedure for writing multiple designs to Flash
Memory reader/writer is essentially the same as
sending multiple design files to machine except
that you select External Media > Write Designs,
Read and Erase. See
Sending or receiving
multiple designs
for details.
Outputting to MC1000* machines
If you have selected MC10001 and MC10000 V3.0
or higher as your current machine, the direct
machine connection option is available to you. This
means you can send individual or multiple design
files directly to two possible destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
Try this! Alternatively, you can use an external
‘Flash Memory’ (ATA PC) reader/writer to write
designs in JEF format directly to card. See
Writing
to Flash Memory reader/writer
for details.
Sending the current design to machine
When sending the current design to machine, you
can send the design file directly to two possible
destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
Use Standard > Write to Card to send a design to
an ATA PC card.
Click to write
design to card
Click to change
name of output file
Select destination
folder on ATA PC
card
Use Standard > Send to Machine to send the
current design to a machine for stitching.
Select files to
write
Use buttons to
navigate folders of
display file list
Select source
folder on your PC
Summary of Contents for DigitizerPro
Page 236: ...234 Part IX Software Feature Table ...
